Results 1 to 7 of 7

Thread: machining help needed

  1. #1
    Join Date
    Apr 2007
    Location
    Wa
    Posts
    5,872

    Default machining help needed

    I have a broken part on my tablesaw fence that is not available. Could anyone with a lathe make me a couple of them out of PTFE? They measure 15/16 diameter are 7/17 wide and the hole in the center is .265.

    Last edited by JimClark; 11-09-2018 at 09:35 PM.
    "Our society strives to avoid any possibility of offending anyone – except God.”
    Billy Graham

  2. #2
    Join Date
    Apr 2007
    Location
    MI
    Posts
    3,027

    Default

    Jim are you talking about the roller white roller?
    does it take any stress/load?

    I might be able to get you something off of my 3D printer. Can we improve by adding bearings?

    Either way I need OD, ID, and Width

  3. #3
    Join Date
    Apr 2007
    Location
    Wa
    Posts
    5,872

    Default

    Yes the white bearing. It just holds the back end of the saw fence up and rolls on a piece of Angle iron. The diameter is 15/16 th's width is 7/16th's and the hole is .625

    Sent from my Moto G (4) using Tapatalk
    "Our society strives to avoid any possibility of offending anyone – except God.”
    Billy Graham

  4. #4
    Join Date
    May 2018
    Location
    TX
    Posts
    196

    Default

    It may have worn/shrunk over the years from an original size of 1" x 1/2". If so one of these should work:
    https://www.mcmaster.com/roller-feeders

  5. #5
    Join Date
    Apr 2007
    Location
    Wa
    Posts
    5,872

    Default

    Thanks Mike but I dont see anything there that I could drill out the hole to 17/64 without messing up an expensive roller.
    "Our society strives to avoid any possibility of offending anyone – except God.”
    Billy Graham

  6. #6
    Join Date
    Sep 2013
    Location
    IN
    Posts
    849

    Default

    I hope these get you going......

    saw wheels.jpg

  7. #7
    Join Date
    Apr 2007
    Location
    Wa
    Posts
    5,872

    Default

    Looks great thank you very much. PayPal coming your way

    Sent from my Moto G (4) using Tapatalk
    "Our society strives to avoid any possibility of offending anyone – except God.”
    Billy Graham

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •