Hi all..... Are we finding it better to use an external BEC and batt on this esc...to avoid heat and LVC issues....say..on a 40/92. 1900 kv on 5 or 6s..... Already added another cooling line..... Or ....run as is....? Thanks...
Hi all..... Are we finding it better to use an external BEC and batt on this esc...to avoid heat and LVC issues....say..on a 40/92. 1900 kv on 5 or 6s..... Already added another cooling line..... Or ....run as is....? Thanks...
I run a separate battery and add an 8800uF cap pack to it.
Yes sir
But I run hot setups...6s 2200Kv.
So far, yes.
I put a EBEC on one of my SK 180 and have been running 4082 1600KV on 6s with no problems. Did that from the start after upgrading from the 120 I burnt up to the 180, why risk burning a expensive ESC when the EBEC's are cheap.
Been a while. To confirm, you just pull the red (pos) pin from the esc to receiver plug?
white geico w/2200kv 3674 leopard 53.5mph 4s2p, geico w/ 1800kv outrunner 52mph on 4s2p, genesis w/2200kv castle 53.8 on 4s2p, impulse 31 w/2200kv castle, stock p1 and ul-1
Just the red
Yes. But I use a 3 in. servo extension. disconnect the red wire in the extension. Then you still have a good connection point when you want to program your ESC.
I also do this in twin setups, I use two extensions connected together with the red wire disconnected at the radio end.
Larry
Past NAMBA- P Mono -1 Mile Race Record holder
Past NAMBA- P Sport -1 Mile Race Record holder
Bump & Grind Racing Props -We Like Em Smooth & Wet
Good call. I used to do that but forgot about it.
white geico w/2200kv 3674 leopard 53.5mph 4s2p, geico w/ 1800kv outrunner 52mph on 4s2p, genesis w/2200kv castle 53.8 on 4s2p, impulse 31 w/2200kv castle, stock p1 and ul-1
Sorry
Not all 180's are the V3 model.
The three that I have are V1's - you must use the same three wire set that goes to the Radio Receiver for programming.
Larry
Last edited by TRUCKPULL; 10-05-2018 at 11:24 PM.
Past NAMBA- P Mono -1 Mile Race Record holder
Past NAMBA- P Sport -1 Mile Race Record holder
Bump & Grind Racing Props -We Like Em Smooth & Wet
Didn't know V1's are still around lol, my bad.
However, the op is talking V3 here.
Yup..version 3..separate program port....Thanks for all the responses...gonna use an EBC...and a another cap bank...just to be safe....
Bookmarks