So even with airplane building experience, the questions begin... I used medium CA to join the bottom, sides and formers. Then weighted it down overnight.
Now I'm adding the 3/16" corner strips. The interlocked formers hold very well, but the bottom is butted to the sides. I didn't like the brittle cracking sounds it makes when I fit the strips in the corners. And I did not use accelerator. So I'm epoxying the corner strips in.
This takes longer, but will be much stronger.
Is this overkill?
I read the whole manual, the bottom does get covered with carbon fiber. I just think rough water would pop the bottom corners loose...
Sent from my SM-G950U1 using Tapatalk
Bookmarks