Power to a servo
A mod can shift this if I am in the wrong section. It is just that there are a lot of people here that may have an answer to this one.
I need more power to a servo that is not in a boat, it is in my crawler.
Given that we have a red+black ( I assume power) wires to the servo plus the signal wire that is yellow or orange or white, can I just jump the +ve and -ve from the rx pack straight into the servo and hope that the signal from the rx pack goes there and does its job.
I have a twin servo setup on the rear and a single on the front.
OR should I just bite the bullet and buy some higher power servos.
Merry Christmas to all
See it....find the photos.....sketch it it....build it........with wood
Bookmarks