I build a Smash Shark twin setup 2 x 4S SSS 2960 2200kV motors,
Any advice about this setup ?
I build a Smash Shark twin setup 2 x 4S SSS 2960 2200kV motors,
Any advice about this setup ?
Last edited by Alfa Spirit; 10-01-2018 at 08:16 PM.
Hey guys, I want to use a 600mAh 2S LiFe battery for the Rx, is there somethong special to do ?
Thanks.
Disconnect the red wire in both ESCs RX plugs if they have a BEC.
Paul Upton-Taylor, Greased Weasel Racing.
Aaa yes sorry
Thank you !
Hello Alain, my friend !
How about your first project on brushless boat ?
Have you finally started it ? Drill, drill, drill...
Don't be afraid, it's not so difficult since your Graupner Arrow and Ultra 1600 built 30 years ago
We miss you since you were banned on the other forum...
Cheers !
Plz use a Castle CC BEC RX battery eliminator, WHY, most servos are rated for 6 Volts .also set your end points on the TX so the servo dose not strain the motor
in it.an burn up.
I have not been active for 3+ years because I got into flying, but I see nothing has changed. Beautiful hardware layout on tables , now at least is on a piece of paper with drawings.
Anyway, mouth watering pictures in the past.... I remember those beautiful hulls we were teased with....
Too many boats, not enough time...
Who use SSS brushless motors ?
Not you...
Are SSS Brushless motors better than Leopard ?
I have sss motors in my TFL Pursuit and Rocket for a few years now and they seem to be descent motors for sport FE boat purposes.
Bookmarks