Results 1 to 30 of 34

Thread: Twin outboard install, Fine design 32.

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 02-10-2018, 06:56 PM #1
    RaisedByWolves's Avatar
    RaisedByWolves
    RaisedByWolves is offline Member
    Join Date
    Jun 2017
    Location
    PA
    Posts
    30

    Default Twin outboard install, Fine design 32.

    I started my twin outboard install on this hull after waiting for my linear actuator to arrive for my power trim setup.



    The hull.



    fd32.jpgfd33.jpgfd34.jpg

    The actuator arrived and I got started, but the actuator is was a bust. In communication with the MFG now to try and resolve the issue and I hope I just got a bad sample as it looks like a really nice unit.


    Anyway,I started on making a unified tilt strut to hold both outboards and simplify the tilt alignment.

    This is as far as I got between jobs at work friday. Not a bad start. Both of the motor pivot shaft holes are in and everything is squared up with some preliminary saw cuts to remove the bulk of the unwanted material.

    When complete it should look similar to the drawing.


    IMG_0508[1].jpg
    Attached Images Attached Images
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules