I started my twin outboard install on this hull after waiting for my linear actuator to arrive for my power trim setup.
The hull.
fd32.jpgfd33.jpgfd34.jpg
The actuator arrived and I got started, but the actuator is was a bust. In communication with the MFG now to try and resolve the issue and I hope I just got a bad sample as it looks like a really nice unit.
Anyway,I started on making a unified tilt strut to hold both outboards and simplify the tilt alignment.
This is as far as I got between jobs at work friday. Not a bad start. Both of the motor pivot shaft holes are in and everything is squared up with some preliminary saw cuts to remove the bulk of the unwanted material.
When complete it should look similar to the drawing.
IMG_0508[1].jpg
Bookmarks