Steering servo for my 14'' micro mono ?

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Andris Golts
    Senior Member
    • Jan 2011
    • 504

    #1

    Steering servo for my 14'' micro mono ?

    Hi all tried to fit my Hitec HS-81 into this hull but not enough room so opted for a Hitec HS-65MG but noticed for torque only had 25 oz . Would 25 oz of torque be powerfull enough to steer a 14'' micro mono? Regards Andris Golts
  • Fluid
    Fast and Furious
    • Apr 2007
    • 8012

    #2
    Yes.


    .
    ERROR 403 - This is not the page you are looking for

    Comment

    • NativePaul
      Greased Weasel
      • Feb 2008
      • 2760

      #3
      The HS-65mg has enough torque, but you might want to look at Savox's SH-0257mg and SH-0263mg, or if you have the height SH-0265mg, all have very similar dimensions to the HS-65 bar the 265 being taller.

      They all have the same torque as the HS 65. On the plus side, all have higher speed, all are digital so have far more holding power, and all are considerably cheaper. On the minus side, Savox servos tend to hum more than Hitecs, and they have a partial alloy case making them 1.5-2.5g heavier.
      Paul Upton-Taylor, Greased Weasel Racing.

      Comment

      • Andris Golts
        Senior Member
        • Jan 2011
        • 504

        #4
        Thanks to all for the great information. Regards Andris Golts.

        Comment

        Working...