My HK Pursuit had a warped bottom on it from new. It didn't really cause a lot of problem initially, however when I inlayed the hull I got some small ali channel and taped it to the bottom to flatten out the high spots. I have since blueprinted the bottom of it. My Q mono was as bad, so I used some 20x20x3 steel angle pieces and stuck them to the bottom of the hull with double sided tape then did the inlay to straighten the hull bottom, the carbon inlay when cured keeps it in place. You can choose whether or not to fill and finish the bottom further after that. Oh yeah you have to carefully pry off the taped on angles, a bit of heat from a heat gun on the steel softens the tape adhesive and makes this a bit easier.
NZMPBA 2013, 2016 Open Electric Champion. NZMPBA 2016 P Offshore Champion.
2016 SUHA Q Sport Hydro Hi Points Champion.
BOPMPBC Open Mono, Open Electric Champion.
Bookmarks