Results 1 to 4 of 4

Thread: Programing Swordfish pro 220A-6s no data logging ?

  1. #1
    Join Date
    Jan 2011
    Location
    ON
    Posts
    497

    Default Programing Swordfish pro 220A-6s no data logging ?

    Hi all i have a Swordfish Pro 220A-6S esc i have tried to program the esc using the Hifei V2 program box WILL NOT WORK ! I tried using a fellow club member's V2 program box WILL NOT WORK ! How can i set my parameters if program box's will not work ? Regards Andris Golts.

  2. #2
    Join Date
    Jul 2016
    Location
    IL
    Posts
    4,096

    Default

    I believe it can be done with the transmitter, but I was never successful trying that myself. I bought the bare circuit board style programmer and was able to make my changes that way.
    Vac-U-Tug Jr (13mph)

  3. #3
    Join Date
    Jan 2011
    Location
    ON
    Posts
    497

    Default

    Thanks for the reply fweasel . Regards Andris Golts.

  4. #4
    Join Date
    May 2017
    Location
    OK
    Posts
    1,464

    Default

    One thing I noticed with this same ESC. I also couldn't get the program box to show anything but dashes. I found two things actually. Leave your ESC ON/OFF switch to OFF. Connect the program box then the battery. Then turn the switch ON last. Be sure you're connected to the serial port on the box, not the power port.

    The other thing is to disconnect your motor. This is mentioned in that horrible programming manual, and there is a picture showing it disconnected. Let us know if it works for you!

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •