dear friends, i'd like to check and maybe change the strut slave berings...
how to?
i've take off strut from hull and now?
i think i have to remove the 12mm dice around the ball joint but it's blocked...
am i right?
thanx to all
dear friends, i'd like to check and maybe change the strut slave berings...
how to?
i've take off strut from hull and now?
i think i have to remove the 12mm dice around the ball joint but it's blocked...
am i right?
thanx to all
HPR 115 kevlar bulletproof @90mph, MHZ Rapid carbonfiber, Bingo Race Minieco
Futaba AIR TX/RX system with telemetry
The ball is threaded. Unscrew it. Carefull drilling out the brass sleeve the drill bit will want to grab.
Sorry but i do not understand well...
What i have to unscrew?
What i have to drill? The bearing to pull it out? From where?
It is crazy no pics all over the web.. damn...
HPR 115 kevlar bulletproof @90mph, MHZ Rapid carbonfiber, Bingo Race Minieco
Futaba AIR TX/RX system with telemetry
Unscrew the ball. I used a paper towel and pliers. If you want to pull the sleeve out you might be able to tap it out with a punch but I drilled mine with a drill bit.
And the "dice" should unscrew too.
wow so difficult...
anyway from where i have to unscrew the ball?
the dice is blocked... crc and a lighter to make it hot just done.. no way...
i've some brand new sleeve bearings... maybe they don't fit...
i've start this job coz i found a black stripe at the end of the drive shaft...
HPR 115 kevlar bulletproof @90mph, MHZ Rapid carbonfiber, Bingo Race Minieco
Futaba AIR TX/RX system with telemetry
Bookmarks