I always like these posts on the car forums I frequent. Not everyone has a dedicated build thread, and its fun to see what was getting tweaked on the work bench.

I swapped out an ADS outrunner for a Turnigy 2836 3200Kv in my Barbwire XL. Drilled out the motor mount to make room for the new stainless collet and just nicked the lower cooling passage. A little JB Weld and it's as good as new.

2017-02-25 13.15.32.jpg2017-02-25 13.16.15.jpg

Installed a swim deck on the Spartan, cooling bulkhead fittings, and replumbed the cooling lines. I've been correcting a lot of sins from the previous owner. The boat is my "beater" and I get a kick out of working on it. Its nice to have a hull that can get scratched up, banged around in the car, and driven by "guests" at the lake.

2017-02-25 15.00.44.jpg2017-02-25 15.11.34.jpg2017-02-25 15.14.41.jpg