Page 2 of 2 FirstFirst 12
Results 31 to 39 of 39

Thread: ML Boatworks RSX380 , The big brother to the RSX310, 38", 6s lipo- Q FE Rigger!

  1. #31

    Default

    Quote Originally Posted by MarkF View Post
    Well I'm glad they were all built to plans Jay. Were they also the same kit I'm building? Did any of them glue the skis upside down like I did?
    Here is a pic showing how much room is in this boat. Those are 6s 5000 packs with room to move them back and forth 2". That's a 4070 motor. Looks pretty small in there. I think i will be able to get all the equipment in this boat without having to use the cowl.

    Mark
    �� Is there be room for a twin motors and drives in there?

  2. #32

    Default

    Yes I believe so. The tub is 4" or 100mm wide. While a pair of 40 series TP motors will fit. I would go with a pair of 3060 size motors if going twins. Now you got me thinking dangit.

    Mark

  3. #33
    Join Date
    May 2017
    Location
    OK
    Posts
    1,316

    Default

    Don’t ya just hate that? Ahhh, the what-ifs!

  4. #34

    Default

    Making some headway on the boat. It's got 3 coats of resin and is now ready for paint and then clear coat. Then I can start assembly.

    Mark
    Attached Images Attached Images

  5. #35

    Default

    I finally got a little paint on the boat. Now I can actually start the electronics build. I hope to have it ready to go by next weekend.

    Mark
    Attached Images Attached Images

  6. #36

    Default

    Iv'e been asked by a few where i mounted all my gear so here are some pics. The motor is a TP 4070 1570KV, 2215 prop from Brian B and speedmaster hardware. Gps hit 79.9 mph with this set up. I tried to get some video last time out but there were too many ducks and I was constantly getting yelled at to slow down and watch for them. So no good video yet but the boat flat out hauls and drives like a dream.

    Mark
    Attached Images Attached Images

  7. #37

    Default

    Wow! 79mph your flying in a heat race. Looking nice and mean.

  8. #38

    Default

    Very nice indeed. Having troubles getting my 310 tub together. warping...
    Club Galvatron

  9. #39

    Default

    You have to build on a flat board and clamp as much down as you can. The tub can only be warped if you dont clamp and then bond your top deck on.
    Laser cut, birch plywood rc race boat kits- WWW.MLBOATWORKSRC.COM WWW.WOODRCBOATKITS.COM

Page 2 of 2 FirstFirst 12

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •