I suspect you can. There are also different sizes with wider or narrower temp bands.
I suspect you can. There are also different sizes with wider or narrower temp bands.
Tyler Garrard
NAMBA 639/IMPBA 20525
T-Hydro @ 142.94mph former WR
Anyone see this yet?? Muhahahaha
http://www.offshoreelectrics.com/pro...rod=rev-ys5000
32" carbon rivercat single 4s 102mph, 27” mini Rivercat 92mph, kbb34 91mph, jessej micro cat(too fast) was
Just noticed it today.
Proboat Voracity-E 36" , Proboat Zelos 36 Twin , Proboat Miss Geico 29" , Traxxas Spartan, Fightercat Daytona, Zonda
Sorry my progress is slacking. I've been busy cleaning up after this massive flood we had here in Louisiana. I might get back to this stuff this weekend. I've got a rigger that puffs batts like crazy and I just got some graphenes in for it to put them to a true test. Stay tuned.
32" carbon rivercat single 4s 102mph, 27” mini Rivercat 92mph, kbb34 91mph, jessej micro cat(too fast) was
Unfortunately not for me. Rc has taken a back seat for the time being due to the flooding we've experienced. Maybe ince I get my house back in order I can get back to it.
32" carbon rivercat single 4s 102mph, 27” mini Rivercat 92mph, kbb34 91mph, jessej micro cat(too fast) was
I have absolutley tortured two pair of the 420blend 3s 2600mah 70c go-packs in my 1/8 buggy. Pushed me into tripple digits. Hook up the old 435blend 5800mah packs and due to the added weight didn't see a gain. These packs don't get as warm as non graphene packs and I have run them too low for comfort and they didn't care. Cant vouch for the 435 HV packs yet.
How is the IR looking on these new graphene packs overall? Especially Revos'.
Haven't seen anyone mention that yet ...
My Revo 3S packs are sitting right at 0.8mohm per cell. Only about 5-6 cycles on them so far. Conversely, my Turnigy 3S graphenes bought at the same time, run in the same boat, cycled the same number of times are a tad higher at 1.1mohm per cell.
Last edited by fweasel; 10-10-2016 at 10:18 PM.
Vac-U-Tug Jr (13mph)
Thats surprising.
Last edited by dmitry100; 10-23-2016 at 10:18 PM.
So I have a set of four Revo blend 435 Graphenes, I have been 'running them in' on my sport mono. On this one I may need to start keeping a timer for running as these sucker just keep going full tilt till the end. I have been plugging them into the charger and finding 15% left in the packs. This IS lower than I normally take my packs but I have no ill effects at this point. I did not pay attention to IR yet but will try next round.
BTW next round should be a direct back to back run with my Revo blend 427's and the Graphenes in my Fantasm.
Just my two cents
Nice srilash, post a follow up with IR readings and noticeable results you have in comparison!
Revo Blend420 Graphene IR data after 6 cycles...charged on Revo GT500...very good!!
srislash, any performance follow ups?
IMG_0227.jpgYes, man these guys charge quick when you double up the amps. Here is a pic of my charge screen with my 6s battery.
So pretty much 1 ohm per cell. My other charger was reading 1.2 ohm per cell on charge.
I just thought I would add to this. I have got quite a few cycles on these and they are still registering 1.3-1.4 ohm on charge.
We are talking milliohms, right?
The swelling always leaves ya nervous! Something got tweaked in there...
Bookmarks