Need advice on ESC

[MG1234]

Currently running 5 turnagy ESC ,s in my boats ,need some new ones for my zonda ,running 4082-1800 kv leopards on 6s,I don't need any data ,I'm thinking hifei 220, and I'll water proof them with epoxy like the forum says,last run on the turnagy 180's got some salt water on them and they ran my boat wide open up on shore ,so I want to completely water proof whatever I buy ,I think I'll rubber dip the 180's ,just want to make a bunch of fast passes just for fun ,what do you think? Thanks

[srislash]

Epoxy has been the only successful WP'ing for me. I have tried the liquid electrical tape, and conformal coating and both for that matter. I am just doing a pair of Phoenix Ice's for BlownAway and am about to epoxy them. I had one go bad on me through cooling seepage.

Shawn

[MG1234]

Do you know if a seaking can be taken apart?

[srislash]

Do you know if a seaking can be taken apart?

I only have the older versions and have taken them apart. Also had good luck putting liquid electrical tape over the seam where the plastic meets aluminum housing.