Speed looks pretty average for that SV27. You need to make sure there is a gap at the drive dog that is the thickness of the cable otherwise the cable gets bound up and gets twisted. The Kintec cable uses thicker wire that is also better quality. You just pull out the old teflon liner, you should inspect that as well for melted areas. Another thing I would check to see is if the motor/collar is aligned correctly to the stuffing tube where the shaft comes out. You don't want it pressing against the stuffing tube, that can cause heat and stress as well causing issues with the shaft.
NEVER SATISFIED RACING
Fine Design 32 V-Hull 4082+6s
Bookmarks