FS: Brandnew Neu 1512 1Y S

[ziggy355]

Hey guys, well I'm new to the site and going to get into the water scence next season but I have a brandnew Neu motor for sale. The store I bought it from sent me the wrong motor so I have no need for it now. Im asking $180 for it obo. I live in the Etobicoke area and will meet localy. Call me anytime 416-834-1419. Here are a few pics of the motor. Thanks for looking guys.

[Raydee]

Please explain what "Brand new new used Neu motor means? Is the motor Brand New or used?

[ziggy355]

[QUOTE=Raydee;58874]Please explain what "Brand new new used Neu motor means? Is the motor Brand New or used?[/QUOTE


Sorry that was a typo. It is brandnew.

[westbeach]

Ziggy,

Brand new motor?? Has this motor been run at all because the wires looked like they have been soldered previously. And the shaft looks to have been milled with a flat spot?
Just verifying your statement.

[mechengineer03]

Ziggy,

Brand new motor?? Has this motor been run at all because the wires looked like they have been soldered previously. And the shaft looks to have been milled with a flat spot?
Just verifying your statement.

You can also see where two different set screw indentant on the flat spot of the shaft has been from something having been on the shaft twice (prop etc.)! Maybe it was just test fit, but need to clear up as I am interested as well.

TODD

[thrashmetal]

he is my racing teammate and i suggested to him that he post it for sale on offshore electrics.

he ordered this neu motor for his e-revo and had installed it and soldered it into his e-revo but never ran it. he had also put on a novak pinion

a few of us had noticed that it was a smooth can motor which was a dead giveaway that it wasnt the proper motor for his appilcation.

once he found this out he removed the motor from his e-revo and replaced it with a finned can neu 1515 1.5 y.


the other neu motor went back into the box. this is the motor he has for sale.

[ziggy355]

Ziggy,

Brand new motor?? Has this motor been run at all because the wires looked like they have been soldered previously. And the shaft looks to have been milled with a flat spot?
Just verifying your statement.

like my teamate states....it was installed in my E-Revo but never ran. It was installed and uninstalled in a matter of mins...hope this helps...

[ziggy355]

You can also see where two different set screw indentant on the flat spot of the shaft has been from something having been on the shaft twice (prop etc.)! Maybe it was just test fit, but need to clear up as I am interested as well.

TODD

yes I did install a set screw for test fitting reasons but thats it. Motor has never had power to it at all....Brandnew never ran...hope this helps..

[ziggy355]

sorry for any confusion guys...but the motor is new and never used. It was installed and taken out within mins.. hope this helps..