Yes. You could use a strut bushing at the end to center it if you wanted to. You don't have to be I recommend it.
32" carbon rivercat single 4s 102mph, 27” mini Rivercat 92mph, kbb34 91mph, jessej micro cat(too fast) was
You don't have any problems with vibration or wiping of the flex shaft? I will try to dig up a bushing of some sort...I was just wondering how you keep the water out and the grease in? Post pictures of your impulse 31's with the .187 flex shafts installed.
" Do you really need anouther boat "
YEP!
So nobody has any pictures....
" Do you really need anouther boat "
YEP!
I've had this setup for 2+ years. I do not have issues with water leakage as long as I frequently grease the thing. It does make a lot of noise, but it runs great.
32" carbon rivercat single 4s 102mph, 27” mini Rivercat 92mph, kbb34 91mph, jessej micro cat(too fast) was
More importantly is that the shaft is under sized. I had trouble getting my coupler to hold when I got one like that. Had a heck of a time figuring out what was wrong with it.
Noisy person
Most 3/16 flex cable will not measure 0.1875". its usually under by a few thousandths.
Nortavlag Bulc
Ray, remember that P Wildthing I used to run? Kept spinning the shafts in it. That was the problem.
Noisy person
Bookmarks