I have used Shoe Goo in the past to hold my servo's in place in Fiberglass hulls.
I am putting a new Mono together.
I have put in a inner liner in the bottom of Carbon Fiber Cloth and a 1" seam tape around the seam on the inside.
Now the area where the servo will be mounted is Carbon Fiber Cloth.
Can I still Shoe Goo and what prep would be needed on the new inlay?
My other choice is Black 5200 marine glue, I am going to use this for the motor mount, and the battery tray's.
The only problem with using this to mount the servo, is you would have a VERY hard time removing it if you had to change a servo.
Larry
Bookmarks