Results 1 to 9 of 9

Thread: Dumas Hawk FE

  1. #1

    Default Dumas Hawk FE

    Maiden voyage dinogy 5000mah 14.8 42mm Graupner K series prop

    https://youtu.be/ZUfHhsvkFAI
    Attached Images Attached Images
    Keith Geusic #677 NAMBA District 19 Seaducer Gas MONO, Aquacraft Revolt Fe30, 30in Max Cat scratch Built

  2. #2

    Default

    just wondering if you can help me out, have picked up a hawk partly built but no info or plans with it so i am trying to find out the distance from the rear to where the flex tube drops put of the hull. Cheers Dale.

  3. #3

    Default

    Three-year-old thread, and the OP hasn’t been on the site for over two years. Don’t expect him to reply....



    .
    ERROR 604 - Caller's Buffer Is Too Small
    1. Ensure that your port is not configured to a mini plug
    2. If you are still having problems, contact someone

  4. #4

    Default

    Ok thanks, just trying to get some info on the hawk.

  5. #5

    Default

    let me know all the info you need about setting up the Hawk as my mate has one so i can get measurements from him.

  6. #6

    Default

    Only rely need to no the distance from the transom to where the flex tube drops out of the bottom of the hull, cheers.

  7. #7

    Default

    the Hawk has an S bent shaft log so it is best if you fit the motor first and then cut out the shaft log slot to suit. remember the Hawk was designed for glow power not electric so your going to have to re position where the motor is to be . you can either mount the motor as close to the rear sponson boom as you can and adjust esc and battery pack to suit c.o.g. or mount the motor in the radio bay compartment section close to bulkhead and position esc and battery up front. Look at the zippkits jae 21/fe build threads and take note where the motor is mounted, not sure if theres enough space to fit the battery pack / s between the sponson booms on the Hawk. the idea is to get the correct c.o.g. and then the Hawk will go well.
    Last edited by rol243; 06-09-2018 at 03:15 AM.

  8. #8

    Default

    Cheers, that is a great . It will be a slow build so i get it set up just right.

  9. #9

    Default

    If you can find any info on the Hawk 3.5 that designer Gary Pruess [ not sure on spelling ] did some years ago, this will also be handy for you as he did some upgrade mods that makes this rigger handle even better. lets us know how you progress.

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •