5.5 Parallel Adapter Set

[dethow]

I have two sets of these which were purchased from Kintec at $15 each set. They were never used.

SOLD Both Sets
$10 each set shipped to lower 48
or $17.50 for both sets shipped to lower 48

Prices are firm unless you are purchasing any other items I have up for sale in which case I can work with you due to savings for all being shipped in one box.

[tlandauer]

I will take BOTH of therm!
Thanks!

[dethow]

I will take BOTH of therm!
Thanks!

Cool... I sent you a PM with my PayPal.
Have you reviewed my other items for sale?
I can cut you a small break on other prices if I can ship items together.

[tlandauer]

The motors are great but I already have a stash, thanks for asking but I will just take the parallel adapters.
Sending funds.

[dethow]

SOLD!
Payment Received. I will get these shipped out tomorrow 8/6.

Thanks

[tlandauer]

Dave,
Thanks so much. items arrived just as described and in meticulously packaged box!
Cheers!

[dmitry100]

What kind of plugs are those? I'm trying to find some quality long style 5.5's for high amp use (200-300a) ... can't seem to come across any aside from german sites (nessel).

[tlandauer]

What kind of plugs are those? I'm trying to find some quality long style 5.5's for high amp use (200-300a) ... can't seem to come across any aside from german sites (nessel).

You are not alone, although I never was looking for long pronged ones, there are different ones and the quality varies. The plugs that Kintec makes for the adapters seem to be in good quality as far as fitting snugly and not loosing the springy feel on the prongs. The prongs are medium long, not too short, but more importantly they MESH with the female, the fit is critically important as I have seen long ones that had poor fit and the alloy quality was so bad, no tension and the prongs actually break off if you try to adjust them.
I have used OSE's all these years and they are better than some you can buy from eBAY or HobbyKing. Castle Creations are good. I would move to a larger diameter if the quality of the 5.5mm doesn't satisfy your requirement.

[dmitry100]

tlandauer: Would it even be worth bothering with the 8.0 castles for 250-300A setups? Or are they kind of hard to connect/disconnect compared to the 6mm ones?