Help with HD flex cable and 5mm -187 coupler.

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Trevor Boyd
    Junior Member
    • Sep 2014
    • 3

    #1

    Help with HD flex cable and 5mm -187 coupler.

    Hello all, i recently picked up those two items and a new prop from the shop and i am just curious as to how it is supposed to install. seems a bit snug using the stock motor. i do realize this setup is primarily for upgraded motors, however the site still says it can be used for stock. Teflon liner is out. I was hoping someone who has done this already may shed some light and or post some pictures. much appreciated.

    Trevor.
  • IRON-PAWW
    Senior Member
    • Oct 2011
    • 314

    #2
    Did you get this sorted yet Trevor? Not quite sure what you mean by too snug with the stock motor.
    PERTH AUSTRALIA
    || 2 x SV 27R || Impulse 31 - ver1 || Traxxas Spartan || Kintec Pursuit || Zonda Cat 41" || Insane FE30 || OuterLimits 870mm || TFL Ariane 36" || ProBoat Zelos 48 ||

    Comment

    • ray schrauwen
      Fast Electric Addict!
      • Apr 2007
      • 9471

      #3
      The coupler if it is steel, might be a tight fit onto motor shaft because it has machining burrs inside that can be fixed with 320 grit paper wrapped around a drill bit small enough to get inside to de-burr it.
      Nortavlag Bulc

      Comment

      • Trevor Boyd
        Junior Member
        • Sep 2014
        • 3

        #4
        hello. iron i have not had a chance to try it yet. i will post a picture hopefully this friday when i will have a sec to work on it. i will let you know !

        Comment

        • Trevor Boyd
          Junior Member
          • Sep 2014
          • 3

          #5
          thanks ray. i will test again and see.

          Comment

          Working...