Results 1 to 4 of 4

Thread: Swordfish 240HV procedure

  1. 07-12-2015, 01:41 PM #1
    T.S.Davis's Avatar
    T.S.Davis
    T.S.Davis is offline Fast Electric Addict!
    Join Date
    Oct 2009
    Location
    MI
    Posts
    6,191

    Default Swordfish 240HV procedure

    Okay, here I am again trying to make a SW fire. Not very optimistic but I'll ask again.

    What is the procedure to arm/calibrate a Swordfish ESC?
    Noisy person
    Reply With Quote Reply With Quote
  2. 07-12-2015, 04:26 PM #2
    wuzofoz
    wuzofoz is offline Member
    Join Date
    Jan 2015
    Location
    QL
    Posts
    54

    Default

    i only have 220amp pro version. not sure if the same.
    to calibrate hold at full throttle and power up esc. you will have a tune then 4 single beeps. during those 4 beeps return trigger to middle and you'll get last beeps.
    to arm i just plug in and give a little blip on throttle after it beeps

    hope this helps
    wuz
    Reply With Quote Reply With Quote
  3. 07-12-2015, 05:30 PM #3
    T.S.Davis's Avatar
    T.S.Davis
    T.S.Davis is offline Fast Electric Addict!
    Join Date
    Oct 2009
    Location
    MI
    Posts
    6,191

    Default

    Thanks. I finally did figure it out. Tried it on a 120 too. Now just need to see if it works.
    Noisy person
    Reply With Quote Reply With Quote
  4. 07-12-2015, 07:20 PM #4
    oscarel's Avatar
    oscarel
    oscarel is offline Fast Electric Addict!
    Join Date
    Dec 2009
    Location
    TX
    Posts
    2,039

    Default

    http://www.hifei.com/#!swordfish-esc/cidm
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules