So I have been looking around at all the different servos out there, low profile, standard, 1/4 scale, and I'm wondering what is the general rule of thumb as far as amount of torque that is needed. I know metal gear is pretty much a requirement. How important are other factors such as speed. Obviously you don't want a super slow servo but is there such a thing as too fast?*!**
I have talked about this at the local lake with gas guys and they all say a servo with at least 250-300oz/in of torque, but I have seen and own some fe twins that have less than that and one is a fairly large hull. The only servo I have that's even above 300 is a savox that I bought on a whim cus it was super cheap for what it is, and it's at 448oz/in.
Bookmarks