If I'm running two lipo packs too a swordfish 240 esc will I be ok soldering a Y setup on the esc.. (like a stock traxxas erevo esc comes set up).
Swordfish 240 esc 2 pack lipo setup
Collapse
X
-
Tags: None
-
Why do you need a "Y"? if you are connecting the batteries in series, just hook up the batteries' + to- and the other + and - goes to the ESC.DSCN3213_3438.jpg
if it is parallel then you need a parallel adapter . Kintec Parallel adapter.jpg
I am assuming you are using bullet connecters.Too many boats, not enough time... -
***edit*** this only applies is your doing them in series. You never stated one way or the other.
Here's how I did mine...
This a seaking 180. I did the wires the same. Run the red one way, black the other and then a jumper between the positive left on one battery to the negative on the other battery. Essentially makes a loop through them. You can see it better on the swordfish 240. That black wire going under it is just a jumper. Hope this helps.
Last edited by kfxguy; 12-12-2014, 02:02 AM.32" carbon rivercat single 4s 102mph, 27” mini Rivercat 92mph, kbb34 91mph, jessej micro cat(too fast) wasComment
-
-
Comment