Got a upgraded flex shaft for the Impulse 31 its to long! Can you cut the flex shaft and do you have to do anything to it when its cut?
Cutting Flex Shaft
Collapse
X
-
I usually solder it then cut with a dremel
Sent from my iPhone using TapatalkThere's a hole at the center of earth where the rest of the world sinks but i stand still... -
NEED PARALLEL CONNECTORS?? QUALITY 5.5MM, 8MM, 8 AND 10 AWG, GET THEM HERE:http://forums.offshoreelectrics.com/...est!&highlight=
Comment
-
Comment
-
Using a Dremel with a cut-off wheel, cut the flex cable a bit longer then required, use acid flux which comes in a small bottle with a dripper-tip from the local hardware store, a small butane torch and solder. Heat some solder into a small molten pool, heat the flex end and drip the flux on the cable as you rotate the end in a pool of molten solder, so it soaks up the solder, evenly. Clean and cut to length.Pete
Motley Crew, Impulse 31, Zonda Cat, Genesis, Aqua Rider tug, E-Revo Brushless, Slash4x4Comment
Comment