Got a upgraded flex shaft for the Impulse 31 its to long! Can you cut the flex shaft and do you have to do anything to it when its cut?
Got a upgraded flex shaft for the Impulse 31 its to long! Can you cut the flex shaft and do you have to do anything to it when its cut?
I usually solder it then cut with a dremel
Sent from my iPhone using Tapatalk
There's a hole at the center of earth where the rest of the world sinks but i stand still...
I use this cutting attatchment on mine
http://www.zoro.com/i/G3086702/?utm_...FehzMgod1WoA0g
NEED PARALLEL CONNECTORS?? QUALITY 5.5MM, 8MM, 8 AND 10 AWG, GET THEM HERE: https://forums.offshoreelectrics.com/...est!&highlight=
Using a Dremel with a cut-off wheel, cut the flex cable a bit longer then required, use acid flux which comes in a small bottle with a dripper-tip from the local hardware store, a small butane torch and solder. Heat some solder into a small molten pool, heat the flex end and drip the flux on the cable as you rotate the end in a pool of molten solder, so it soaks up the solder, evenly. Clean and cut to length.
Pete
Motley Crew, Impulse 31, Zonda Cat, Genesis, Aqua Rider tug, E-Revo Brushless, Slash4x4
Bookmarks