I have added a set of trim tabs and also replaced my strut. All seems well except when I go full out the boat goes on edge to the right side.
Is this what is known s torque roll?? Should I be adjusting the trim tabs or my strut?
I have added a set of trim tabs and also replaced my strut. All seems well except when I go full out the boat goes on edge to the right side.
Is this what is known s torque roll?? Should I be adjusting the trim tabs or my strut?
Your boat is most likely running wet and the torque roll from the prop tilts it a bit which is then magnified by wet running. Take your tabs up a bit.
NEED PARALLEL CONNECTORS?? QUALITY 5.5MM, 8MM, 8 AND 10 AWG, GET THEM HERE: https://forums.offshoreelectrics.com/...est!&highlight=
Also adjust the strut up about 2mm. I found that when I put my strut too low the boat would torque roll.
37" Fightercat Shocker powered by Neu 1530 on 10S
Bookmarks