Sent from my C771 using Tapatalk 2
Brand New Mini Mono ESC Questions. 2013
Collapse
X
-
I have almost the same configuration, but the tream tabs are wider but not larger (from the aquacraft Rio).....not good solition. I am building news one, so to eliminate the torque bounce.
If you get a better solution, share it :)
Also running 430 prop, 432 was too much torque.
Here is a pinture and I will post a video later
By the way, nice MM and trailer.
ImageUploadedByTapatalk HD1362448269.282049.jpg
Sent from my iPad using Tapatalk HDComment
-
I would like to see some video of how it is running with the side to side torque.
The prop is a little big for that hull, And you should make some longer trim tabs for it.
Try a 30mm prop and adding about 1/2" longer to the stock size trim tabs and 1/2"wider.
You will need to nip the starboard side one to miss the rudder bracket,
But I think it may help a lot with it.
There are a couple other mods you could do to the hull setup,
To make it handle better, But not sure on how far you want to go in modding things.Comment
-
Sent from my C771 using Tapatalk 2Attached FilesComment
-
Yes I just looked at your album,
Looks like a nice truck with the mystic.
Also can you take a picture right now of your mystic inside setup ?
I need to check something on it.Comment
-
Comment
-
Sent from my C771 using Tapatalk 2Comment
-
Can you explain how you do the self-rising modification in the cowling? Does it work every time?
If you have picture….it would be great.
Thanks.Comment
-
I just cut a hole in the cowling and when its upside down it fills with water and slowly rolls to the side because the weight in the bottom, and then I add some throttle.
Sent from my C771 using Tapatalk 2Attached FilesComment
-
I fabricated some new trim tabs from some old aluminum I had in the shop. What do you think?
Sent from my C771 using Tapatalk 2Comment
-
They will definitely do the job….seems to me a little longer ¿?
I will build mines on the weekend, but I will not cut the turn fins.
Thanks for the sharing pictures.Comment
-
They're 1 1/2 inches wide at the rear, and one inch at the front.
The tab from the hull to the end is 1 1/2". And overall is 1 3/4" inches.
the material I used is thinner than the stock tabs, so I might need to install mine on top of the new ones for support.
Sent from my C771 using Tapatalk 2Comment
Comment