flex cable

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Sobie2
    Junior Member
    • Sep 2012
    • 13

    #16
    It has been way to long, but I pulled out the old driveshaft, and enlarged the hole in the transom and front shaft support. I cut the 098 stuffing tube and teflon liner tube, and inserted the wohlt driveshaft (the one that I got appeared to be only an octura 098 assembled driveshaft cut to length and thus it wouldn't fit the existing stuffing tube. At any rate I have some epoxy and will epoxy it in tonight. The only thing I need to do is check the length the driveshaft needs to be sticking out of the stern before I set it in place. Then it is off to the water!

    Sobie2

    Comment

    Working...