thrust bearing.JPGthrust bearing 2.JPGNo oil to MB.JPGAcergoo Speed grease.jpg
Look and learn from my screw ups.
In my attempt to make an already great new boat better I have caused my own problems. So I want to share my screw ups with everyone so we all can get these Re Volts flying. At 35-38 mph I am too used to it, because my old boats ran this speed. Running 45 mph keeps my attention HA!!! HAVE FUN BE SAFE. Mike
k.i.s.s. Keep it simple stupid..... Oh boy this could have really been bad because I installed a Thrust bearing on my motor and to my surprise it did GREAT job of cutting off oil to motor bearing. NOT A GOOD THING. Removing thrust bearing!!! Since I researched the 695Z motor bear (s) which can handle all the propeller end thrust without any problem! I am buying BOCA Ceramic one's I will let you people know how they work I believe it will be good.
I was lazy and just used ACERGOO instead of walking ten steps to get my Grim Speed Grease. Do not use ACERGOO on any boat cable drive because Yikes it caused quick-accelerated wear on prop stub Yikes. ACERGOO works great on my RC cars and trucks so don't take this wrong. Wonder how they would do with Grim SG? BTW ACER offers SIN Lube which I did use on my motor bearings nice lube.
Grim,
Thank you for designing this boat I promise not to screw it up anymore.
Mike
P.S. Are the 695Z bearings Flanged or non-Flanged? And have you tried them?
Bookmarks