Results 1 to 3 of 3

Thread: Strut height

  1. #1
    Join Date
    Mar 2011
    Location
    BC
    Posts
    7,629

    Default Strut height

    Hey guys,I am putting together a PB Miss Bud (same as Elam)and am going to set a new stuffing tube with a exterior strut.What I need to know is roughly the height of the strut so I can epoxy my tube in.Thanks in advance, Shawn

    So to add;this is a partially converted hull that I got.Here is what I have so far

    The motor is a Hacker B50 6XL 2630kv



    It came with the rudder and I got this strut for it



    And it had a broken tube in it and the old setup was removed



    So if you guys can help me set my strut height so that I don't end up putting too much pressure on it later with adjustments it would be appreciated.Thanks again
    Last edited by srislash; 07-05-2012 at 11:56 AM.

  2. #2
    Join Date
    Nov 2010
    Location
    OR
    Posts
    2,493

    Default

    Did you ever get the strut figured out if not let me know and I can tell you what mine is set at.
    OSE GIFTING ELF
    HAPPY HOLIDAYS!!

  3. #3
    Join Date
    Mar 2011
    Location
    BC
    Posts
    7,629

    Default

    I got it running fairly well.Changed to a 1512 2650 motor,set the strut centerline at 5/8 from the bottom where the strut is not the rear pads.This isn't a very good vid to see how it runs but http://www.youtube.com/watch?v=guG4R...&feature=g-upl

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •