I have a new batch ready to ship!!
Jeff
I have a new batch ready to ship!!
Jeff
Thanks for the quick shipping... 12 Volt ordered and shipped. Thanks!
Hi Jeff,
How much the overseas shipping for one 12v unit to Chile?
Sent from my GT-N7000 using Tapatalk 2
Shipping will be $50 to chile thats usps
they will do either they are self switching
Payment sent!
Sent from my iPad using Tapatalk HD
I got my 12v unit, shipped to Chile.
Works perfect!
Thanks.
Sent from my iPad using Tapatalk HD
Good deal Glad you like it. Thank you Jeff
Would like (1) 24 volt power supply.
Thanks
sent you PM
Hi guys, I have many more of these ready to go!!!
Jeff
Guys I bought a 24 volt setup from Jeff some time back and I will definitely say once again that it is awesome. It's still running strong and stays cool as heck while charging a pair of 6s 5000 man and a pain of 5s 5000 mah at 10 amps each and another single 6s 5000 mah on another charger at 15 amps. I am over specs but it still works flawlessly.
my youtube videos http://www.youtube.com/user/chris81983?feature=mhee
How much for shipping to Singapore? I'm interested in the 24V setup.
Medium flat rate if $59 USPS WOW!! It was $33. Thats not very cost effective.
Wow, thanks, USPS rates have gone up quite a bit. Let me think about it.
Eric , Please check it out, maybe I am not seeing it right, A 24v weigh less than 8 lbs boxes and ready to go. USPS is usually the cheapest.
I have many ready to ship.
I have a handicap stair climber that runs on 24v. It requires new batteries every year ($70) Would a 24V unit work and run a wire to the chair?
I honestly have no idea
Well I purchased a couple almost 1 1/2 years ago and one finally gave up the ghost. I need another. Please PM me so I can get your PP and I will send you my address. Thanks
Gary
I bought four of them as a 2S2P unit for ~250USD, after a little more than 12 months three of them stopped working, one is still doing its job.
regards,
Manuel
I think it is my fault. I charge in the garage where there is a lot of dust. I took the unit apart and it was filled. I am going to figure a way to put a mesh screen where the fan is and do the same to my Hyperion chargers. One of the little fans on it is making noise. I think I will clean the inside of them also. They are expensive.
Bookmarks