I just couldn't not post this. Some of you have a thing for geicos so here goes.....
The guy I sold my original Rivercat to had this idea to build a nice geico similar to my Rivercat build. No problem. So I reinforced the crap out of this thing and flooded the sponson bottoms with epoxy and chopped carbon. Tips, tunnel and transom too. Then I did carbon strips down the whole seams of the boat. Then a nice honey comb inlay. After I was done I got nervous at the weight of the boat. I was scared it wasn't going to perform well. Here's the layout
Lehner 1940 18xxkv with fan
Savox lo profile servo
Seaking 180
Mbp collet
.187 flex for reliability
Carbon motor mount
Billet servo mount
Stock hardware
Abc 1615 prop (41mm)
Inlay
Here's the layout
Bookmarks