Results 1 to 3 of 3

Thread: My AquaCraft Rio EP Brushless Project

  1. #1
    Join Date
    Dec 2011
    Location
    OR
    Posts
    66

    Post --

    Deleted Due To Lack of Interest...
    Last edited by Billy Barnacle; 02-25-2013 at 02:18 AM.

  2. #2
    Join Date
    Apr 2011
    Location
    CA
    Posts
    5,666

    Default

    Very nice! The square tubing is a great idea , wish AQ thought of that, the round tubes don't do anything. Now only if one can solder these square tubes on the plate, but I don't know if it's even possible.
    Always liked your mod on the Rio, I had gone a different route and my much lower 1500kv PB motor did not give me torque roll , but I am sure yours is faster. There are trade-offs. I used a 42mm plastic prop, was too cheap to go with a "real" prop. lol...
    I crashed my Rio once, straight onto the shore, Lenny has been reminding me to look out for the trees now!
    I am sure with all the info you provided, someone who is thinking along these lines would benefit from your first hand knowledge/opinion.
    Cheers!

  3. #3
    Join Date
    May 2012
    Location
    IL
    Posts
    940

    Default

    Billy,
    Great info I think I will try one of those motors in my Re Volt. Yes life has a way of screwing with our Hobby time.
    Mike

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •