I have a cat running twin leopard brushless motors, 2 swordfish 240 HV esc
running 10s lipo's in parrallel.
The 2 Swordfish 240 ESC seem to be going into lvc, even though the packs are 100% charged.
The boat would run for about 3 seconds then slow down to a stop. Release the
trigger, pull again and it would run again for another 3 seconds and do the
same thing.
I had the LVC set to 10s and soft cut out at 3.3v. I decided to set the LVC
to auto and see if that would fix the problem but still the same thing.
Packs are 2 fully charged 10s 5000 mah hooked up as a 10s 2p setup. Packs
are thunderpower 30c 5000mah.
Boat ran good when I first bought the esc early on in the year, then i didnt
use the boat for a few months , now this.
Motors, esc's and batteries all cool.
I changed the receiver and y cable to make sure that that wasnt the problem, changed the receiver battery,
but I'm still getting the same result.
I read on the swordfish site that the esc would go into auto shut down if there was a signal lost or
interference. I thought maybe the servo might have been interfering with the reciever so I diconnected it but still the same thing
Im using a futaba fasst 2.4 ghz radio set on HRS mode.
ESC are less than 12 months old. Its strange how both ESC are doing the exact same thing.
Any ideas would be apreciated.
Peter
Bookmarks