What is the best way to keep the sleeve from coming out and spinning on the cable shaft
it is on my 46" AC razor
DSC_1314.jpgDSC_1315.jpg
What is the best way to keep the sleeve from coming out and spinning on the cable shaft
it is on my 46" AC razor
DSC_1314.jpgDSC_1315.jpg
That looks perfectly normal! It is designed to "float" and the little lip will keep it from sliding in too far.
"Look good doin' it"
See the fleet
it will slide all the way to the prop collet and spin is that ok seems strange
like jesse said… it is designed to work that way. dont try to keep it from sliding, thats what it is supposed to do.
Thanks for the help it didn't look right Does the gap look right it i took it out for its first run today it is scary fast running 55mm prop with 10s not sure of top speed
The best rule of thumb is to leave a gap equal to the diameter of the flex cable.
.
ERROR 403 - This is not the page you are looking for
yep that is how i set it up..... just overthinking my first 46" boat with almost as much HP as a riding lawn mower thanks for the help
Bookmarks