Still none the wiser..

[makin' waves]

Hi guys,

couldn't find any threads on how to change deans for 5.5 bullet connectors on my batteries,
and no replies to my first post...?

Please I could do with some help!

Thanks
Tone

[1truckerdan]

It is not hard to do, just take your time .
I myself do them one at a time to reduce the risk of shorting out the batteries ( touching the (+ red) to the (- black) can be really bad ).
I unsolder one side of the deans plug from the wire connected to the battery, then solder on the bullet connector and add shrink wrap (so it can't touch the other wire)
....then do the other one the same way.
Usually from the battery I put a female bullet and on the (+ red) wire and a male on the (- black) wire......Just make sure the bullets on your ESC match the batteries bullets (+ on battery to the + on the ESC and the - to the -)
That way you can run your packs in series without any additional jumper wires.
I hope this helps
Daniel

[makin' waves]

Thanks Daniel,

Thats a great help!

Tone