Anyone know what a good replacement is? The stuffing tube is too short without it and the prop shaft has a lot of play. I forgot about it, I heard it hit the ground, then the garage troll grabbed it
May just have to get a Speedmaster strut now
Anyone know what a good replacement is? The stuffing tube is too short without it and the prop shaft has a lot of play. I forgot about it, I heard it hit the ground, then the garage troll grabbed it
May just have to get a Speedmaster strut now
are talking about the little white washer?
PRB4100_Gal7.jpg
I suspect this is what he wants:
ERROR 403 - This is not the page you are looking for
http://www.offshoreelectrics.com/pro...ckets+%26+Moreif its that ose sells them just need to know the size:
I'm talking about the tapered coller that goes on the end of the strut that mates the stuffing tube to the strut. Without it there is a gap for water to travel up the stuffing tube and for the prop shaft to vibrate.
You asked about the collar on the back end of the strut, but you meant the one on the front of the strut? I am not aware that the piece is sold separately, you'll either have to make a replacement yourself, or buy a new strut assembly.
http://www.horizonhobby.com/Products...ProdID=PRB4105
ERROR 403 - This is not the page you are looking for
JackBlack, I have one you can have
Land, Sea & Air, A true RC Addict.
does any one else have one or know where i can get one? any help would be a big help. Thank you
Bookmarks