Im looking for some help with my ICE 120HV controller. I have two of them in a 37" cat hull and tried it out for the first time today. One ESC acts like it cant find proper timing and shuts down quickly (I can even do it on the bench at times). I checked all my connections and they are good. I switched ESCs in the boat and put them on opposite motors and the problem followed the ESC. I tried playing with timing and PWM rate to see if it made a difference but it didn't. I even tried spraying it with corrosion x in case it was a mosture issue (although there was no water in the boat whatsoever) but that did not work either.
Each time the data logger shows 300A+ on that ESC and shows "over current detected".
Any help would be appreciated. I bought these ESCs NIB but from a OSE member so I dont have a receipt.
Bookmarks