Hi all, First, thanks for all your advice, every little bit helps.
Ok, what I did today is remove mount and motor and reverse it.In order to do that I had to remove motor coupler and teflon liner, as liner was too long to clear coupler, and still use factory motor mount holes on the side of the tub when reinstalling it all.
I took a pic of what has been done so far, I am holding the coupler approx. where I believe it fits, or close to it.I think I have to trim the stuffing tube and the liner to get about the correct spacing for clearance for stuffing tube and liner.I will trim the stuffing tube at the second line from the motor, leaving room for the liner to protrude.I also have to cut the flex cable or get a new one, as now, it's way too long.I am getting a new one, from OSE.I'm not sure I can get all the grease out of the other one.
Please tell me what you guys think, does it look like I actually know what I'm doing?
Bookmarks