Picture how to ... any questions - just ask.
Picture how to ... any questions - just ask.
IMPBA 20481S D-12
Great stuff, I think I might have to borrow that idea, that'll help me shorten things up.
egneg u selling these things now with every prop?
MY RETIREMENT PLAN?????.....POWERBALL
74 vintage kirby clasic hydro, pursuit mono, mg, 47'' mono, popeye hydro...
Smaller banana plugs will do if you don't have the brass rod.
Can you post some pics of how these look in your boat. I still can't picture how they are set up?
Do you drill a hole through your connectors? My bullet connectors only have one hole in them...
Joe
You can ... but the CC connectors I use have 2 holes and no cutout section.
IMPBA 20481S D-12
I just bought some Castle 5.5's at the LHS and they dont have the thru hole Just curious if you have a part # for the Castles you get?
DF-29,Phil Thomas Super Sport 45, SV27, Xzess 2 Evo, HOTR 32" Cat
Yup just one side.
I will have to double check ... as CC bullets used to be the only ones I bought.
IMPBA 20481S D-12
egneg that picture of your set up is all I needed to get mine done...
Thanks,
Joe
Thats a very good Idea. The only thing I would change is to use copper tubbing instead of the brass since it conducts electricity a little better.
Mark
DSC02320.JPGDSC02321.JPGChuck, a big thanks for this idea
Some 8's I made for a customer :
2008 NAMBA P-Mono & P-Offshore Nat'l 2-Lap Record Holder; '15 P-Cat, P-Ltd Cat 2-Lap
2009/2010 NAMBA P-Sport Hydro Nat'l 2-Lap Record Holder, '13 SCSTA P-Ltd Cat High Points
'11 NAMBA [P-Ltd] : Mono, Offshore, OPC, Sport Hydro; '06 LSO, '12,'13,'14 P Ltd Cat /Mono
Thanks for all the help here on making the double connection out of the bullet connectors... I went on line and on ebay found Tough Racing out of Seoul Korea, they have the 5.5 bullets with holes though both ends.... I got ten pairs with shrink wrap tubing for like $8.00 shipped to my house... Took less than two weeks to get them...
Last edited by Joe007; 07-05-2011 at 09:47 PM.
Heres a new twist...
HobbyKing 8mm bullets. .155 solid brass rod- right thru the stock holes!
I made mine to fit the batteries. So I have 2 males/1 female, 2 females/1 male
i made a set with cc 6.5 bullets but still havent found heat shrink big enough , help here with that
if your heat shrink is close to the size but not quit the right size streatch it with a pair of needle nose plyers...heat will bring it back to size
MY RETIREMENT PLAN?????.....POWERBALL
74 vintage kirby clasic hydro, pursuit mono, mg, 47'' mono, popeye hydro...
Bookmarks