I've seen several variations on this method. Some just use the center void. Here's a simple way to use the entire plate. IIRC I've seen something pretty close to this way of doing it. Here's how I did it :
Drilled through the side passages into the center void. (Relieved the side-fin with a dremel to allow clearance for drill bit)
Tapped the outside wall of the side-passage tube with a 6-32 tap & blocked off with set screws sealed with JB
Made block-off plates for the ends of the center passage with some scrap aluminum & carefully JB'd to attach & seal
Water enters the first tube-passage, enters the center void, does its heat exchange, exits into the other tube-passage & out the hull exit.
I'll pressure test as soon as the JB cures.
2008 NAMBA P-Mono & P-Offshore Nat'l 2-Lap Record Holder; '15 P-Cat, P-Ltd Cat 2-Lap
2009/2010 NAMBA P-Sport Hydro Nat'l 2-Lap Record Holder, '13 SCSTA P-Ltd Cat High Points
'11 NAMBA [P-Ltd] : Mono, Offshore, OPC, Sport Hydro; '06 LSO, '12,'13,'14 P Ltd Cat /Mono
Bookmarks