Hi Steven,
Do you have an idea when you will be getting more of the Swordfish 120's in stock? I would like to try a couple. Also which programmer do you recommend: the USB or the card?
Thanks,
Mike
Hi Steven,
Do you have an idea when you will be getting more of the Swordfish 120's in stock? I would like to try a couple. Also which programmer do you recommend: the USB or the card?
Thanks,
Mike
My personal choice is the box.
I will have a couple next week and a large batch in about 3 weeks.
Steven Vaccaro
Where Racing on a Budget is a Reality!
Ok, thanks for the reply.
Mike
Hey Steven,
Are those 120's still on schedule to be here this week? When you say "box" do you mean the seaking/hobbywing box or is there a specific Sordfish programming box? The Sordfish listing mentions a USB or a Card. Nothing of a box.
thanks
Mike
I'm hoping so.
Here is a link to all the swordfish stuff.
http://www.offshoreelectrics.com/sea...e=&scat=&sman=
Steven Vaccaro
Where Racing on a Budget is a Reality!
ahhhhhh.... got it, thanks! sorry for the confusion.
Mike
No its my confusion. In the text i can it an lcd programmer. I should have said the same thing here. The best thing about the usb is that its the only method that you can update the esc's firmware with(if needed). but its also a bit of a pain to install on some pc's.
Steven Vaccaro
Where Racing on a Budget is a Reality!
Thanks Steven,
I just put in an order!
Thanks
Mike
Hey Steven, when do you expect more SF 240hv to come in stock? thanks
Very soon. I hope this week or next week.
Steven Vaccaro
Where Racing on a Budget is a Reality!
Steven, Perhaps I missed it elsewhere, but what are the degrees of timing advance for low/standard/high for the 200A LV?
I guess it would be in the manual if I knew where to find it.
Thanks!
IMPBA: 7-Time FE World Record Holder "Don't think outside the box. Rather, refuse to admit that the box exists in the first place!"
MGM Controllers - Giant Power Lipos - ML Boatworks - Wholt's Wire Drives & Struts - Nano-Oil
This may help http://www.astecmodels.co.uk/pdfs/Sw...200A%20ESC.pdf
Option 1: Low advance timing
0°~15°
Recommended for more lower pole count motors. Gives more power and
slightly less efficient.
Option 2: middle advance timing
5 °~ 20 °
Recommended for most motors .Gives a good balance of power and efficiency.
Option 3: High advance timing
15° ~ 30 °
Recommended for most of higher pole count motors
Option4:Auto(default)
Recommended for most of all brushless motors.
Very helpful. Thanks!
IMPBA: 7-Time FE World Record Holder "Don't think outside the box. Rather, refuse to admit that the box exists in the first place!"
MGM Controllers - Giant Power Lipos - ML Boatworks - Wholt's Wire Drives & Struts - Nano-Oil
Can anyone tell me what threads are on the water fittings for the Swordfish 120's? I would like to replace the straight fitting with a 90 degree on one end. Any thoughts?
Bump...
Does anyone know what threads are on the Swordfish water fittings?
Thanks
Mike
Just in case anyone else was interested... They are 4MM
Bookmarks