HI
I have a Hifei Swordfish 240 amp conneted to a Leopard 5692 Motor
I put everything in receier and batteries and the esc turn on but does not work?
And idea?
http://s1218.photobucket.com/albums/dd412/Jr_Jose1/
[IMG][/IMG]
Thanks
HI
I have a Hifei Swordfish 240 amp conneted to a Leopard 5692 Motor
I put everything in receier and batteries and the esc turn on but does not work?
And idea?
http://s1218.photobucket.com/albums/dd412/Jr_Jose1/
[IMG][/IMG]
Thanks
Are you able to program iit?
calibrate the throttle
may need to rev throttle channel also(futaba)
also youll need a reciver pack for that esc
rev the throttle channel and try and calibrate it does it make any noise when you plug it in
here are the instructions if you dont have them
http://www.astecmodels.co.uk/pdfs/Sw...200A%20ESC.pdf
See 112 and 115 https://forums.offshoreelectrics.com/...aba#post179370
the only way I have been able to calibrate it is with it full throttle and then full reverse to stop , I would like to only have to use the throttle ??
Thanks
got it to work , but the Esc should not turn red at full throttle should it??
what should the Pwm 8khz or 12 , or 16 ?? in the program?
Thanks
i have the 120 and i never even noticed an led
leds on are on the bottom if esc , what i like to know if how to tell if the motor is reaching top rpm correctly? 5692 I have make a very quiet
Thanks
Your short shrunk leads off the ESC motor end are scarin the heck out of me. Please insulate your connectors before the fire works go off.
~~~~~~~~`Mach 5 racing'~~~~~~~~~~~~
****2008/9 MMEU LSO, 2008 LSH CHAMP****
~~~~~~~70 MPH Club Member!~~~~~~~~~
Bookmarks