Results 1 to 4 of 4

Thread: 150 etti ESC Configuration

  1. #1
    Join Date
    May 2010
    Location
    NS
    Posts
    237

    Default 150 etti ESC Configuration

    Hello All,
    Can anyone shed some light on the wiring for a Capacitor bank to the ESC?

    There is a plug point on the ESC with 2 wires, is this the connection point?

    Thankyou for your input.
    Mick

  2. #2
    Join Date
    Jan 2009
    Location
    WA
    Posts
    45

    Default

    Here is an install picture.
    http://www.offshoreelectrics.com/pro...tti-caps-3.jpg
    As close to the esc as possible.


    Cheers

  3. #3
    Join Date
    May 2010
    Location
    NS
    Posts
    237

    Default

    Ok thanks, this changes the setting up considerably
    Any idea's on what the extra 2 wire pin plug is for then?

    Thanks
    Mick

  4. #4
    Join Date
    Jan 2009
    Location
    WA
    Posts
    45

    Default

    I believe its an RPM sensor. But it must use the ETTI Power analyser to work. I havnt used it but it would be good to know the Revs of the motor to se if your pushing it too hard.

    Cheers

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •