Hello, my first thread here. I have done a lot of testing with this boat so far, and I am over-all very happy with it. I am also very happy with Venom's support. So far after 40-50 runs I've had two problems. One was with the transmitter (it still worked but was buggy) sent it back, and they sent me a new one right away, and the port trim tab needed to be relocated as it was not flush with the boat. I've also had a few of the glue/resin joints let go, but I am sure that has been from the pretty intense crashes I've had. Flexible CA is "DA BOMB" on these boats, and on marine stuff. A couple drops and it was all good again.
I hate to post a link to another forum, but I did a pretty intensive write as I went with this boat on RC groups, and I don't want to have to repeat all the info here, so here is the link:
http://www.rcgroups.com/forums/showthread.php?t=1320827
I have been through 3 props so far, and I just got in 3 more from OSE. Hopefully I will have time to work on them, and do some more testing before it gets too cold out. I have a ton of videos on this boat, including a music video I made(music by me, just a live recording while watching the video). The two most impressive are these:
http://www.youtube.com/watch?v=UjlYFbd1Spg
and a brief 6S run (need to do more testing with props before I go 6S again:
http://www.youtube.com/watch?v=RyFgJtc2scM
Anthony.
I think possibly I cannot embed video yet, as this is my first post.
Bookmarks