Results 1 to 3 of 3

Thread: Timing Turnigy Typhoon Outrunner

  1. 10-26-2010, 11:08 AM #1
    ezhitz's Avatar
    ezhitz
    ezhitz is offline Senior Member
    Join Date
    Aug 2009
    Location
    On
    Posts
    422

    Default Timing Turnigy Typhoon Outrunner

    Just wondering what i should set the timing at on the Turnigy Typhoon 500 (1800kv) outrunner? Right now it's set at 15 degrees motor ran fine but after about 3 minutes of running time it was around 155f and i wasn't sure if thats to hot for an out runner.

    thanks
    :canada
    Reply With Quote Reply With Quote
  2. 10-26-2010, 03:25 PM #2
    syncronized77's Avatar
    syncronized77
    syncronized77 is offline Senior Member
    Join Date
    Jun 2010
    Location
    AB
    Posts
    277

    Default

    I run 20+ degrees timing on my Typhoon 500 in my BJ26 on 4S with an x642. Temps are less than 110F every run.

    What setup are you running....do you have watercooling?
    Go Brushless or GO HOME
    Reply With Quote Reply With Quote
  3. 10-26-2010, 10:24 PM #3
    ezhitz's Avatar
    ezhitz
    ezhitz is offline Senior Member
    Join Date
    Aug 2009
    Location
    On
    Posts
    422

    Default

    Hi thanks i will try bumping up the timing on the turnigy 120 it can go up to 18.75 or 22.50 degrees so I can try both to see.
    Yes I have a water cooled mount its in a 30" balsawood cat running a prather 220prop.
    http://www.youtube.com/watch?v=CgPEpn7TOJ8
    :canada
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules