anybody had success using the tx to program?
Its driving me nuts!
anybody had success using the tx to program?
Its driving me nuts!
Yup. You running a spektrum radio?
Yes i have a spektrum dx3
Is that a problem?
Forgot to mention its a Castle hydra 120
Not a problem but a hastle. Make sure all the end points are 100 percent then go real slow to reverse. That's where we always go wrong in our club. For what ever reason we can never get past reverse.
Yes it worked. Took multiple tries. When it did finally work I went real slow to reverse. Don't know if that was the trick or just got lucky. Is that is what's happening to you? It won't recognize reverse?
I'm just plain confused with all the beeps!
In fact i hate the stupid thnng
Then the solution is dumb-simple - get the Castle Link!
http://www.offshoreelectrics.com/pro...s-link&cat=136
.
ERROR 403 - This is not the page you are looking for
i use a mac.
i will keep trying with the tx until i have no hair!
So you're telling us you don't even know anyone with a PC? What a sad story.....i use a mac.
.
ERROR 403 - This is not the page you are looking for
The instructions to set up the esc with the tx are very poor....beep this beep that what the f.
looks like you have to use a pc or go mental.
now i have to buy the link thing and use the pc at work.
Is it just a matter of D/L the software and plugging the thing in,or do i have to go into the control panel and change ports?
My cheap asian esc's have stand alone program cards.sigh
Bookmarks