Results 1 to 4 of 4

Thread: Etti cap board question

  1. 09-24-2010, 08:26 PM #1
    britscoot's Avatar
    britscoot
    britscoot is offline Senior Member
    Join Date
    Jul 2010
    Location
    fl
    Posts
    656

    Default Etti cap board question

    after soldering on the board,what do you use to insulate the exposed solder join?
    Also,is it ok to shorten the wires from the esc to the motor?

    cheers..
    Reply With Quote Reply With Quote
  2. 09-25-2010, 11:51 AM #2
    properchopper's Avatar
    properchopper
    properchopper is offline rcgoatbuild@snotmail.com
    Join Date
    Apr 2007
    Location
    ca
    Posts
    6,963

    Default

    Shrink tube.

    Yes.

    [ remember that if you shorten the wires for one application, they may end up being too short for another].
    Attached Images Attached Images
    2008 NAMBA P-Mono & P-Offshore Nat'l 2-Lap Record Holder; '15 P-Cat, P-Ltd Cat 2-Lap
    2009/2010 NAMBA P-Sport Hydro Nat'l 2-Lap Record Holder, '13 SCSTA P-Ltd Cat High Points
    '11 NAMBA [P-Ltd] : Mono, Offshore, OPC, Sport Hydro; '06 LSO, '12,'13,'14 P Ltd Cat /Mono
    Reply With Quote Reply With Quote
  3. 09-25-2010, 12:53 PM #3
    britscoot's Avatar
    britscoot
    britscoot is offline Senior Member
    Join Date
    Jul 2010
    Location
    fl
    Posts
    656

    Default

    Thanks Tony.
    Cant believe i didnt think of that...duh
    Reply With Quote Reply With Quote
  4. 09-30-2010, 08:09 PM #4
    darioellider
    darioellider is offline Junior Member
    Join Date
    Dec 2009
    Location
    Es
    Posts
    19

    Default

    exactly
    what do it???? i don´t undestand
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules